Softener Regeneration Troubleshooting in Township Of Washington, NJ

Softener Regeneration Troubleshooting in Township Of Washington, NJ

Softener regeneration troubleshooting in Township Of Washington, NJ is about finding which part of the cycle is failing. A regeneration runs in steps: backwash, brine draw and slow rinse, fast rinse, and brine refill. Township Of Washington, NJ Water Softener Installation watches each one to see where it breaks down.

Common problems and what usually causes them:

• Never regenerates. Clock not set, power lost, meter turbine stuck, or a failed motor
• Regenerates but no softening. No brine draw from a plugged injector, salt bridge or air leak at the brine line
• Brine tank overflowing. Stuck float, a refill controller letting too much water in, or a drain line that's restricted
• Salty tap water. Slow rinse cut short or a cracked injector letting brine through
• Stuck in backwash. Worn piston seals or a seized drive gear

We force a manual regeneration and time each step with the valve cover off. Then we test the output water once the cycle finishes. Often the fix is a cleaned injector, a new brine line O-ring or a seal kit. Sometimes it's a programming problem after a power outage reset the valve to factory settings.

For softener regeneration troubleshooting and water softener repair in Township Of Washington, NJ, call Township Of Washington, NJ Water Softener Installation at (833) 995-0133.